This is the steering kit that comes with the RetroBuster.  Order this is you want four wheel steering on your truck.

Includes:

• Standard G10 steering plate.
• Extreme clearance G10 steering plate.
• Front side of gear box G10 servo mount
• Aluminum servo brackets
• ABEC-5 Ball bearings
• YeahRun M4 Rod Ends
• 70mm Aluminum Link
• Hardware

The RetroBuster comes with an upfront style steering setup.  It uses aluminum servo mounts and a ball bearing plate steering link.  Two choices of g10 steering links are included, a straight one and one that has an arch if you need more steering motion (doesn't hit the gear box).  Turning this is a 70mm m4 rod with two rod ends on it.  I included a simple servo horn as well that I like.  All required hardware is included as well.

Retro2 racing is not very fast, so I do not believe you will need a servo saver installed.  However if you put some wild modified motors in this as I suspect some will do, I recommend a servo saver and you may need to update to a stronger steering link.  I do not think the 3mm G10 will survive wild modified motors.    An stronger steering link is on the list for future plans.

*Tip*  place your servo in the aluminum brackets and tighten down the bolts holding the brackets.  Remove the servo and install the servo plate to the gear box.  Make sure to put the 1 mm washer between your gear box and servo plate otherwise your servo will not site properly.  Tighten the plate mount bolts with the two included nuts. unfortunately you can not tighten the aluminum servo mounts if you have the plate installed, this is why you need to follow this steps.

Order now at Bent Axle Bill!